User Tools
gui-cs-status-en
Differences
This shows you the differences between two versions of the page.
| — |
gui-cs-status-en [2018/11/12 08:56] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ======Status Light====== | ||
| + | {{ rocrail-logo-32.png}} | ||
| + | [[english|Content]] -> [[english#rocview|Rocview]] -> [[english#general|General]] | ||
| + | * [[rocgui-config-en|Configuration]] | [[loc-tab-en|Locomotives Tab]] | [[gui-accel-en|Accelerators]] | **[[gui-cs-status-en|Status Light]]** | [[gui-multi-en|Use multiple Gui's for viewing]] | [[gui-reports-en|Reports]] | ||
| + | |||
| + | // \\ // \\ | ||
| + | **What do the status lights (bulbs) indicate.** \\ | ||
| + | |||
| + | =====From left to right===== | ||
| + | {{:status-bulbs.png}}\\ | ||
| + | * Green = OK or active. | ||
| + | |||
| + | >**Note:** The definition is also displayed with the mouse pointer on the lamp as a tool tip. | ||
| + | |||
| + | ====1 Plan health==== | ||
| + | * The startup **[[planhealth-en|track plan health status]]**.\\ In case of red check the Rocrail server trace e.g. in the __**[[tracefilter-en|Trace filter]]**__ | ||
| + | |||
| + | ====2 Power==== | ||
| + | * Global track power. | ||
| + | |||
| + | ====3 Communication==== | ||
| + | * Command Station Connection | ||
| + | * The RS232 or TCP/IP successfully initialized and connected. | ||
| + | * **DDX**: The RS232 could be successfully initialized to generate digital signal for mobile decoders. | ||
| + | |||
| + | ====4 Sensors==== | ||
| + | * Sensor system | ||
| + | * Ready for processing Sensor report events. | ||
| + | * **DDX**: The parallel port could be successfully initialized to poll s88 compatible decoders. | ||
| + | * **mcs2**: The sensor state will be green after the first sensor/s88 event has been received in case polling is disabled. | ||
| + | |||
| + | ====5 Accessory==== | ||
| + | * Accessory system | ||
| + | * Ready for controlling accessory decoders. | ||
| + | * **DDX**: The RS232 could be successfully initialized to generate digital signal for stationary decoders. | ||
| + | |||
| + | ====6 Auto mode==== | ||
| + | * Ready to run trains in auto mode. | ||
| + | |||
| + | ====7 Init field==== | ||
| + | * Init field is ready. This lamp is green after Rocview is started, and will go red on the Init Field command. | ||
| + | |||
| + | \\ | ||
| + | |||
| + | ===== Remarks ===== | ||
| + | Not all command stations report a separate status for sensor and accessory systems and will remain red.\\ | ||
| + | |||
gui-cs-status-en.txt ยท Last modified: 2018/11/12 08:56 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
