User Tools

Site Tools


loconet:dtopsw-nl
no way to compare when less than two revisions

Differences

This shows you the differences between two versions of the page.


loconet:dtopsw-nl [2018/11/12 08:56] (current) – created - external edit 127.0.0.1
Line 1: Line 1:
 +====== Digitrax ======
 +[[:english#rocgui_viewer|{{  :viewer.png}}]][[:english|{{  :rocrail-logo-35.png}}]]
  
 +[[:dutch|Inhoud]] -> [[:dutch#Rocview|Rocview]]-> [[:dutch#Programmeren|Programmeren]]   
 +// \\ // \\
 +
 + 
 +// \\ // \\
 +Digitrax uses **Option Switches** to setup stationary decoders. They can be set by standard switch commands or with special LocoNet commands.\\
 +Rocrail supports with this dialog reading and writing of Option Switches for the following decoders:
 +  * **BDL16x**: current sensors and transponder receiver
 +  * **DS64**: switches
 +  * **SE8**: switches and signals
 + \\
 +| The target decoder must be set in programming mode before option switches can be changed; See manual. |\\
 +
 + \\
 +
 +===== Option Switches Dialog =====
 +{{:loconet:dtopswdlg-en.png}}\\
 +
 + \\
 +==== Address ====
 +This is the board address of the decoder.\\
 +This address cannot be changed with this dialog, you need to check the manual for this.\\ 
 +
 + \\
 +==== Type ====
 +Select the wanted board type to program.\\
 +
 + \\
 +==== Option Switches List ====
 +Each board type has its own set of option switches as is listed after type selection.\\
 +
 + \\
 +==== Read All ====
 +Read all the option switches from the address and type set for the board.\\ 
 +
 + \\
 +==== Write All ====
 +Write all the option switches from the address and type set for the board.\\ 
 +
 +
 +
 + 
loconet/dtopsw-nl.txt · Last modified: 2018/11/12 08:56 by 127.0.0.1