User Tools
users:dagnall53:description
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
users:dagnall53:description [2019/10/07 19:30] dagnall53 |
users:dagnall53:description [2019/10/07 19:35] (current) dagnall53 |
||
|---|---|---|---|
| Line 57: | Line 57: | ||
| {{:users:dagnall53:wirocs_esp8266.jpg?200 |}}{{:users:dagnall53:wirocs_esp32.jpg?200 |}}\\ | {{:users:dagnall53:wirocs_esp8266.jpg?200 |}}{{:users:dagnall53:wirocs_esp32.jpg?200 |}}\\ | ||
| - | + | If you are not using the OLED, you have 8 I/O. Each I/O can be set by Rocrail as an input or output, using the "PI02 Port Setup". | |
| - | PROVIDED that the Pin is not being used for an OLED display, Motor drive, Loco Front or Rear Light or other pre-defined function such as Loco Motor PWM drive, each I/O can be set by Rocrail as an input or output, using the "PI02 Port Setup". | + | |
| This allows blinking, and inversion. | This allows blinking, and inversion. | ||
| + | |||
| + | If you are using the OLED display,you still have 6 I/O for Motor drive, Loco Front or Rear Light or any other pre-defined functiona such as Loco Motor PWM drive, ESP32 users have a full 16 I/O! | ||
| ---- | ---- | ||
users/dagnall53/description.txt · Last modified: 2019/10/07 19:35 by dagnall53
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
