User Tools

Site Tools


arduino:wio-cable-en

Differences

This shows you the differences between two versions of the page.


arduino:wio-cable-en [2024/01/14 09:25] (current) – created - external edit 127.0.0.1
Line 1: Line 1:
 +[[:arduino:wio-overview-fr|{{ icons:fr.png|French Version}}]][[:arduino:wio-overview-de|{{ icons:de.png|Deutsche Version}}]][[:arduino:wio-overview-en|{{ icons:uk.png|English Version}}]]
 +====== WIO CAN Cable ======
 +[[:english|{{ :hardware.png}}]][[:english|{{ :rocrail-logo-35.png}}]]
 +[[:english|Content]] -> [[:hardware-en#arduino|Arduino]]
 +  * [[:arduino:wio-overview-en|WIO Overview]] | [[:arduino:wio-setup-en|WIO Setup]] | [[:arduino:wioctrl-en|WIO Control]] | [[:arduino:amp-en|User Bitmaps]] | [[:arduino:wio-en|WIO Firmware]] | [[:wio:wio-ledscript-en|LEDScript]] | [[:arduino:wio-mobile-en|WIO Mobile]] | **[[:arduino:wio-cable-en|Cable]]**
 + \\
 +
 +
 +=====Screw connector=====
 +{{:arduino:akl_249_04.jpg?200}} {{:arduino:akl230.png}}\\
 +
 + \\
 +^  AKL  ^  Function  ^  CAT-5 color  ^  Remark  ^  
 +| **1** | +12V        | brown + green | power supply +12V |
 +| **2** | CANL        | blue/white    | CAN |
 +| **3** | CANH        | blue          | CAN |
 +| **4** | GND         | brown/white + green/white  | GND |
 +
 +| The Orange/White pair can be used for DCC Booster sync. |\\
 +
 +^  U/UTP  ^  CAT5  ^  1xTP + Power  ^
 +| {{:arduino:utp.jpg?0x300}} | {{:arduino:wio-can-cable-akl-4.jpg?0x300}} | {{:arduino:wio-cable-alt.jpg?0x300}} |
 +| Unshielded UTP cable. | CAT5 cable connection. \\ (Not recommended.) | 1 TP for CAN, separate wires for power supply. |
 +
 + \\
 +=====Patch Cable PCB=====
 +This small PCB makes it possible to use common patch cables:\\
 +{{:arduino:wio-cat5-sch.jpg}} {{:arduino:wio-cat5-pcb.jpg}}\\
 +It has a screw terminal which can be connected to the AKL connector with 4 short wires (max 100 mm).\\
 +An optional CAN bus terminal resistor is also on the PCB, to be activated with JP1.\\
 +The three pin header is to provide DCC signal for booster input.\\
 +This connector should also be connected at WIO_Prog.\\
 +The LED L1, indicates if power is available.\\