User Tools

Site Tools


rocview:blocktrip-en

Differences

This shows you the differences between two versions of the page.


rocview:blocktrip-en [2022/03/02 03:10] (current) – created - external edit 127.0.0.1
Line 1: Line 1:
 +======Block Trip by Signals======
 +[[:english#rocview|{{  :viewer.png}}]][[:english|{{  :rocrail-logo-35.png}}]]
 +[[:english|Content]] -> [[:english#rocview|Rocview ]] -> [[:english#general|General]] 
  
 + \\
 +=====Introduction=====
 +A Block Trip by main signals will reserve all needed routes for the trip, and makes the trip visible.\\
 +
 + \\
 +=====Requirements=====
 +  * The main signals must be added to the __**[[:block-signals-en|Block Properties]]**__.
 +  * The main signals must be set to __**[[:signal-gen-en#operable|None Operable]]**__.
 +  * The blocks used in the trip must have a direct route from one to another.
 +  * The locomotive is placed in the correct direction.
 +  * Each main signal is used only one time at a maximum. 
 +  * The permissions of the locomotive will not be checked during a block trip.
 +
 +|< >|
 +| {{:bktrip:blocktrip_signal_properties-en.png}} |
 +|  **[[:signal-gen-en#operable|Deaktivate signal option "Operable"]]**  |
 + \\
 +=====Define a Trip=====
 +  - Click on the main signal of the block, which the locomotive occupies, on the wanted depart side. (Start of the Trip.)
 +  - Click on the main signal of the next block on the wanted depart side; the route between the two blocks will be reserved.
 +  - And so on until the last block has been added to the trip.
 +  - Start the locomotive in (virtual) automatic mode.
 +  - The locomotive will run the whole trip and stops in the last block of the trip.
 +
 +=====Block Trip Simple Plan=====
 +This is a simple plan for learning the basic handling of a Block Trip. 
 +{{:bktrip:blocktrip_simpel.png|}} \\ \\
 +The corresponding workspace can be found here: {{{{:bktrip:blocktrip_simpel.zip |}} \\
 +
 +=====Block Trip Complex Plan=====
 +This is a complex plan with a virtual block and loops. Remember to use only the exit signals of a block to define the Block Trip. \\
 +Press the Init button to reset everything. \\
 +{{:bktrip:blocktrip01_plan.png|}} \\ \\
 +The corresponding workspace can be found here: {{:bktrip:blocktrip01.zip |}}