besra:german:test
This is an old revision of the document!
Table of Contents
Test Schriftgröße
Normaler Text, wie er im Wiki verwendet wird.
Kleiner geschriebener Text (85%) als Einschub. Hier können spezielle Details erläutert werden, die nicht in allen Fällen relevant sind.
Test Signal-Übersicht nach Typ
Test Signal-Übersicht nach Einsatz
Spezielles: Test
switch-gen-de
Type
Following types are available:
Type | Motors/ Coils | Remark | Symbol/ Positions |
---|---|---|---|
Turnout | 1 | With a curved turnout (this symbol is not available in Rocrail) the outer curve is considered as straight. Positions: Straight, turnout | Left switch Right switch |
Center Crossing | 0 | 90º crossing (no motor/coil) | |
Crossing | 0 | Crossing (no motor/coil) | Crossing left Crossing right |
Crossing (no motor/coil) with option Rectangular: 90º crossing. The left/right option does not affect the visualization. | |||
1 | Double slip switch with one motor like, e.g., Märklin 24624, 2260, 5128. One motor moves all slips, two possible positions Positions: Straight, turnout | Crossing left Crossing right |
|
Crossing with one motor with option Rectangular: 90º crossing. The left/right option does not affect the visualization. Positions: Straight, turnout | |||
Double Crossing | 2 | Two motors moving the slips, max. four positions. Two addresses must be specified! Not to be used for double slip switches with only one motor. These have to be set up as crossings, see above. Positions: Straight, turnout, left, right | Double Crossing left Double Crossing right |
Single Crossing | 2 | Zwei Motoren bewegen die Zungen-Paare. Max. drei mögliche Stellungen. Es müssen zwei Adressen angegeben werden! Es stehen zwei Untergruppen zur Verfügung. Stellungen Untergruppe links: Gerade, abzweigend, links Stellungen Untergruppe rechts: Gerade, abzweigend, rechts | Untergruppe links EKW links EKW rechts |
Untergruppe rechts EKW links EKW rechts |
|||
Dreiweg | 2 | Zwei Zungen-Paare mit separaten Motoren. Stellungen: Gerade, links, rechts | |
Entkuppler | 1 | Es wird empfohlen, einen Entkuppler nicht als Weichen-Objekt, sondern als Taster einzurichten. Dazu muss das Symbol als Ausgangs-Objekt mit SVG #5 definiert werden. Stellungen: Aus, an | |
Zubehör | 1 | ||
Zweiweg | 1 | Zweiweg oder Gleisdreieck. engl. Wikipedia-Seite mit mehr Infos Y-Weiche mit Abzweig entweder nach links oder nach rechts, keine gerade Stellung. Stellungen: Links, rechts |
besra/german/test.1581346989.txt.gz · Last modified: 2020/02/10 16:03 by besra