User Tools

Site Tools


rocnet:rocnetnode-setup-en

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
rocnet:rocnetnode-setup-en [2018/12/04 14:57] – [RocNetNode Configuration] rjversluisrocnet:rocnetnode-setup-en [2022/10/22 08:21] (current) – [Invert] rjversluis
Line 175: Line 175:
  
 ====DCC Type==== ====DCC Type====
-^ Type ^ Description ^ +^ Type ^ Description ^ Devices 
-| none | No DCC support | +| none | No DCC support 
-| **[[:dcc232-en|dcc232]]** | DCC generation on the serial USB device. (Software CS) | +| **[[:dcc232-en|dcc232]]** | DCC generation on the serial USB device. (Software CS) | /dev/ttyUSB0, /dev/ttyUSB1, **[[:gca1-pi01-en#rs232_on_s1|/dev/ttyAMA0]]** 
-| **[[:sprog-en|sprog]]** | SPROG II, SPROG 3 or S-Nano. (Hardware CS) | +| **[[:sprog-en|sprog]]** | SPROG II, SPROG 3 or S-Nano. (Hardware CS) | /dev/ttyUSB0, /dev/ttyUSB1, /dev/ttyACM0 |
 ====DCC Device==== ====DCC Device====
 USB device on which the DCC generator is connected.\\ USB device on which the DCC generator is connected.\\
Line 218: Line 217:
  
 ====Invert==== ====Invert====
-Invert the port level.\\+Invert the output port.\\
  
 ====Test==== ====Test====
Line 404: Line 403:
  \\  \\
  
-=====For Experts===== + 
-====Backup Configuration====+=====Backup Configuration=====
 All configurations are saved in the **rocnetnode.ini** and can be copied to another computer for backup purpose.\\ All configurations are saved in the **rocnetnode.ini** and can be copied to another computer for backup purpose.\\
 The IP address can be easily composed with the **Sub-IP** of the RocNetNode.\\ The IP address can be easily composed with the **Sub-IP** of the RocNetNode.\\
Line 414: Line 413:
 WinSCP or Filezilla can also be used with the **SFTP** protocol.\\  WinSCP or Filezilla can also be used with the **SFTP** protocol.\\ 
  
-===Restore===+====Restore====
 Before restoring the **rocnetnode.ini** the RocNetNode program has to be stopped to prevent overwriting the restored ini file.\\ Before restoring the **rocnetnode.ini** the RocNetNode program has to be stopped to prevent overwriting the restored ini file.\\
 <code> <code>
rocnet/rocnetnode-setup-en.1543931873.txt.gz · Last modified: 2018/12/04 14:57 by rjversluis