Support
Wiki Documentation
Support Forum
Mobile
- Rocweb Browser
- WIO-Control ESP32
- andRoc Android
- Rocview Tablet
DIY
User
Wiki writer
Legal
User Tools
Sidebar
robvrs:wa2-adapter-en
Table of Contents
G WA2 Adapter
Introduction
The WA2 is also known as the "Böhler WA2".
It is produced by Kaleas, and can be ordered under part number 32012.
Files
Sources created with OpenSCODE:
To use this adapter, the point lever must be replaced with the one provided.
The adapter hight measures from bottom to top 20mm.
Parts
Bottom
Depending on which side, and on which switch type, one pair of the screw terminals must be cut off.
The pair left should be extra drilled with 2.5mm to be prepared for threading M3.
Generally the terminal pairs can be assigned the following types:
| A | Left-hand switch |
|---|---|
| B | Right-left switch |
If the mounting side is at the straight side of the switch.
Cover
Point lever
Miscellaneous
- 1 x Spax 2 x 16
- 2 x stainless steel or brass M3 10mm
- 1 x M2 stainless steel 8mm set: bolt, nut and 2 x washer.
Example
The connection between WA-2 and slip lever is done with M2 stainless steel.
Connector
| Pin | Usage | Remark |
|---|---|---|
| 1 | Polarisation + | Used as position A feedback. |
| 2 | Polarisation - | Used as position B feedback. |
| 3 | Polarisation slip | Used as position common GND. |
| 6 | Motor +/- | |
| 7+8 | Motor -/+ |
 |
| Böhler WA1 (Kaleas 32011). The WA2 does not feature a relay, and has 8 pins only. |
Prepare the WA2
Cut off the screw terminals and the small notch:
robvrs/wa2-adapter-en.txt · Last modified: 2021/04/16 19:46 by rjversluis
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
