This is an old revision of the document!
Table of Contents
de: Ein Block für Anfänger
de: Einführung
Hier soll für Anfänger erklärt werden, was ein Block ist, wie ein Block mit Gleisen und Elektronik aufgebaut wird, wie ein Block genutzt wird, …
Eine Lok kann von Block zu Block fahren.
Ein Block sollte immer länger sein als der längste Zug (Lok mit Wagen).
Ein Blocke sollte zwei Rückmelder haben für die Ereignisse ENTER und IN.
Die Block-Kennung lautet "bk01".
Ein Block hat eine Plus- und eine Minus-Seite, um der Software mitzuteilen, auf welcher Seite die Lok in den Block einfährt.
Die Sensoren heißen "fb01+" und "fb01-".
"fb01+" an der Plus-Seite des Blocks;
"fb01-" auf der Minus-Seite des Blocks.
de: weitere Details
Die Rückmelder sollen in diesem Beispiel als Strom-Sensoren realisiert werden.
Die Länge eines Rückmelders sollte so lang sein, dass die Lok innerhalb des Rückmelders zum Stehen kommt (also den Rückmelder nicht überfährt!).
Damit der Block später in beiden Richtungen befahren werden kann, installieren wir die Rückmelder symmetrisch (links un rechts vom Block die Rückmelder-Bereiche von gleicher Länge).
en: configuration
The build in "Router" will configure the feedback sensors with the blocks if the Router is setup appropriate.
Just activate "assign feedbacks to blocks",
- do the routing (Rocview menu / File / Router / Routing)
and it's done.
For the direction of this example the minus side of the block is the "enter" side of the block; so
- sensor "fb01-" is responsible for the "enter" event and
- sensor "fb01+" is responsible for the "in" event .
To be prepared for using the opposite driving direction the plus "enter" side should be setup as well:
- sensor "fb01+" is responsible for the "enter" event and
- sensor "fb01-" is responsible for the "in" event .
As a summary: