BiDiB Setup Examples

Configuration | Setup examples | USB Mapping

Switch setup

Example Servo

Bus → Decimal Unique-ID

This example shows how to address servo port 1 on a LightControl. The accessory flag must be unchecked.
The decimal Unique-ID is set in the Bus field which can be done with D&D.

Parameter/Value

5698+
Optional the servo position can be specified:

Parameter → straight position
Value → thrown position

Example Dual Coil

Disable "Single Gate"

Address + 1 is used for controlling the second coil of the switch motor. (turnout)

DCC Accessory

Field	Value	Remark
Bus	Decimal Unique-ID	Default GBMBoost Master if left empty. If MultiMaus¹⁾ accessory commands should also processed the Bus value must be set to the UID of the GBMBoost Master.
Protocol	NMRA-DCC
Address	1…65536	Is mapped to NMRA 0…65535
Port	Not used
Gate	0, 1	Only for single coil switch motors or Outputs
Type	Accessory

Signal setup

Example MoBaLiSt

Bus → Decimal Unique-ID

This example shows how to address lights port 1…4 on a MoBaLiSt. The accessory flag must be unchecked.
The decimal Unique-ID is set in the Bus field which can be done with D&D.

Sensor setup

Bus → Decimal Unique-ID
Address → Port number + 1

Server trace

MSG_BM_CONFIDENCE: uid=00010068 path=0.0.0.0 void=0 freeze=0 signal=0
sensor bus=00010068 addr=5 state=occ ident=1057 type=loco-addr-fwd

Sensor message
bus	Unique-ID (hex value)
addr	local module port address
state	occupancy: free/occ
ident	Railcom loco address

See http://www.bidib.org/protokoll/bidib_occ.html for more information about confidence.

¹⁾

Or any other Xpressnet throttle.

Innovative Model Railroad Control System

Table of Contents