User Tools

Site Tools


loconet-io-it

I/O

ContenutiRocviewProgrammazione




Usare l'Easy Setup se non si è esperti o se si ha bisogno di impostazioni predefinite.


Registri

La parte di registro rappresenta i byte di configurazione della porta selezionata. (Sola lettura) La colonna sinistra è deicmale e la destra esadecimale.
Questi numeri sono solamente dimostrativi e servono per un controllo veloce del setup dell'I/O.

Configurazione
bit 7 0 = input 1 = output
(0/1) (0/1)
bit 6 active (low / high) (contact / block) detector
bit 5 (switch / push button) (normal / multi)
bit 4 (switch or push button / block detector) (normal / flashing)
bit 3 (OPC_SW_REP / OPC_SW_REQ) (continues / pulse) contact
bit 2 block detection switch off (delayed / direct) reset (software / hardware)
bit 1 not used not used
bit 0 not used (high / low) at start up



Valore 1
bit 7 0
bit 0-6 low part of port address A1-A7


Valore 2
Bit(s) 0 / 1
7 0
6 normal / switch sensor
5 A0 for block detection
output contact C1/C2
4 pulse / continues
0-3 high part of port address A8-A11


SV LocoIO

Il codice operativo OPC_PEER_XFER è usato per scambiare dati tra computer e decoder.
John Jabour ha progettato i PCB dei moduli LocoNet che programmabili anche con le SV.

locoio.pdf

loconet-io-it.txt · Last modified: 2018/11/12 08:56 by 127.0.0.1