Support
Wiki Documentation
Support Forum
Mobile
- Rocweb Browser
- WIO-Control ESP32
- andRoc Android
- Rocview Tablet
DIY
User
Wiki writer
Legal
User Tools
Sidebar
mgv141-programming-fr
GCA141 Wheel counter
Introduction
The programming is similar with the GCA50(LocoIO) and uses LocoNet messages to communicate.
Setup
Use the query tab for selecting a unit.
Change the high and low module address separately and query again.
Reading and writing the counter addresses can be done in one sequence.
mgv141-programming-fr.txt · Last modified: 2018/11/12 08:56 (external edit)
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
