Content → Objects → Turntable

• General | Interface | Tracks | Setup

Bus → Decimal Unique-ID
Address → Port number + 1

• Sound ON/OFF
• Track mapping

No position sensor is needed because it is reported automatically by the controller after the new postion has been reached.
This can take several seconds, and depends on the speed of the motor and the way it has to go for the new position.

Trace snippet:

20180203.105648.534 r9999c cmdrE360 OBiDiB   1025 output 1962942189:0 type 0 set to 14 ((flat addressing))
20180203.105648.564 r9999I bidibrea OBiDiB   3833 MSG_LC_WAIT path=1.0.0.0 type=0 port=0 time=17
20180203.105649.514 r9999I bidibrea OBiDiB   3758 MSG_LC_STAT path=1.0.0.0 port=0 state=14

• https://forum.opendcc.de/wiki/doku.php?id=stepcontrol