Content → Objects → Turntable

• General | Interface | Tracks | Setup | Traverser setup
  • LocDec | DigitalBahn | MultiPort | F6915 | AccDec | slx815 | d15 | dsm

fl6915-dcc.pdf
Only switch commands are needed to control the 6915.

The interface address can be left empty because the decoder address must be set for every track; See Tracks.
The bridge side with the operator shed is conducted to the wanted position; The 'Red' gate of the decoder address is used to establish this.

The 6915 controller does not report when the bridge is in position, so it is not possible to use this controller in auto mode.
A work around could be the delay option.

The controller type fl6915 can be also used for the Digikeijs DR5020 turntable decoder.
This controller is able to report when the bridge is in position, defined as "Position Sensor" in the turntable interface tab.